If you can’t simply upgrade to the latest version of APx500 (you are running a custom. Instructions for installing and running APx500 (v2.6 or earlier) in XP mode:ĪPx500 v2.6 and earlier run normally on 32-bit Windows 7, but must be run in “XP Mode” on 64-bit Windows 7. APx500 v4.5 or later require a 64-bit Windows operating system.The instrument must be connected to the PC using an ISA, PCI, PCIE, or PCMCIA APIB interface adapter.Will not run under Windows 7, even in XP Mode.Requires separate driver installation for Windows 8.When you close the AP2700 software, you will see a Windows error message (“AP2700 3.30 has encountered a problem and needs to close.”)-this can safely be ignored. It appears to be recognized in the Windows Device Manager, however, when you run the AP2700 software, an error message on the IEC 61937 panel indicates that the Dolby Digital hardware is not found. The 2700 Series OPT-2711 Dolby Digital Generator option can not be used.A USB-APIB Adapter for the System Two Cascade, Cascade Plus, 2700 Series, and ATS-2 may be purchased from AP. The instrument must be connected to the PC using the USB interface-the PCI, PCIE, and PCMCIA APIB interface adapters can not be used.Must be run in Windows 7 XP mode, see instructions below.Some models and options require a minimum version of APx500.AP Software Windows Version Compatibility Chart SoftwareĢ700 Series, System Two Cascade & Cascade Plus
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |